adminuf.blogg.se - Ansys apdl commands extrude

Temp: 205 ☌, here (but tweaking this hasn't had any effect).

Layer height: 0.24 mm (in the pictures, but replicated with 0.16 mm also).

The printer is a Monoprice Maker Select V2. Is there some setting that I should be tweaking? I've exhausted my own ideas of different tweaks to no avail. Here you can see that by the time it finishes, it's just fine, and also what a contrast is between the start and end. Here you can see it start at the tip and get gradually better as it progresses.

I have disabled retraction with no effect. The top layers seem fine (despite starting in the same place). Strangely, this only occurs on the layers with infill. Just fine on one side, but terrible on the other, precisely where it starts the layer. In this picture, the problem is on the outer wall (see red outer line, the print head is moving counter clockwise.Īnd here is the print showing the issue. It starts the layer in the same place every time, so it results in this vertical line, on one side of which is fine (where it finishes the layer) and the other side has bad gaps and the wall is much thinner. I have a severe under extrusion when the printer starts the outer wall, which is resolved by the time it finishes the outer wall.